work in progress so far

Noted and adjusted Arcaster (y) Can't wait to paint as i'm a vehicle paintsprayer by trade . I've been a painter for about 25 years now but hey got to be patient and get the panelling right first :)
 
Hey Jake, got a better view with the armour on ya! I 'think' that the plates are a little on the large side? (see attached pic, excuse size of image) I understand that your a tall guy but they seem a little on the large side when compared to the pics. (just my 2 pence).

Armourpost.jpg


Maybe.. and it is a maybe that when you've added the contours to them that they'll 'appear' smaller?
Don't get me wrong I think they look great so far but could be allot better with a little work.

p.s. Paint sprayer?? hmmmm will send ya a PM. ;)
 
Cheers Mojofett , i did base the plates on Wizzards XL templates i suppose i should've remembered our US mates XLs are more like our XXL but not a problem as can cut down to a L . Had a feeling may get a pm lol saw yer Thread :lol:
 
I think the armor is OK, but the vest seems small on you, this is why you don't have enough room to fit the armor plates properly. The vest should be longer in lenght and maybe wider on the shoulders, especially that the shoulder area doesn't look good. Did you buy the vest already made or it was made to your measurements?
 
I was thinking the armor looks a bit large on you as well, but like rafal said it might be that the vest is a little too small. Or maybe a combination of both.
 
adjusted 1.jpgHi guys , as to Rafs question i had vest made by Cucblack . I was wearing quite a thick jumper when i took the pics but did feel it was a little short . I also felt myself the armor was a little big so have adjusted from XL to L , i have rough placed them although i've still to adjust collar . Thanks for the feedback guys :cheers
 
Whilst contemplating the adjustments to my flac i decided to start weathering my boots, still some way to go but here's so far

boots 3.jpg


boots 2.jpg


boots 1.jpg
 
Well after passing a kidney stone this morning and feeling like death (my poor little feller ;) ) was feeling better this afternoon so i decided on finishing my cod all bar the paint . ( Even added a dents just for you Raf :D )

cod comp 3.jpg


cod comp 2.jpg


cod comp 1.jpg
 
Last edited by a moderator:
Good job so far! The toe spikes should be fixed by moving the spike closer to the screw and maybe shorten it a bit, like this:

Boba-Fett-Costume-First-Prototype-12.jpg Boba-Fett-Costume-First-Prototype-13.jpg
 
Cheers Guys , done a little more on the knees earlier ( dart blocks and filler ) and put in the dent just for you Archaster ;). Photos will follow soon ! :cheers
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top