WIP ROTJ Boba Fett

martinisoft

New Hunter
This has been in the works for roughly 6 years now when I bought some ROTJ parts off a friend at a convention. For years the parts sat in my closet because of a lack of time, money and energy to complete the whole suit. I'm finally in a spot where I have time and energy to devote to getting this finished. The first parts I started with were second hand, but the vest was made by TK409.

So far all I have is the vest with attached chest and shoulder armor, wookie braids and installed electronics for the chest plate. I've also got the cod piece and butt plate along with the knee plates, back plate and cape. I lost the collar plate during a move when it got cracked down the middle, so I'll need to replace that part. Just recently, I got a new bucket and flightsuit from bobamaker, which were nothing short of impressive. Looking to hopefully finish this up just past the New Year.

Gallery: Boba Project - Imgur

Test fitting with everything I have so far, new bucket and flight suit from bobamaker
5pUYy.jpgUfVmt.jpg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top