Tool Pocket Measurements

Jedi Bob

Well-Known Hunter
Is there a definite size for these two pockets. My PP jumsuit has them being really big and while the pockets are being moved, I might as well make as many corrections now.

Thanks
 
I dont think there are any "accurate measurements" out there, I would just size them to snugly fit whatever shin tools you have. That's just my stupid opinion, so ignore it if you want to.
 
It all depends on if you are going to use real Paterson tools or resin copies. The resin RA sonic beam weapon I have is about half the size of the Paterson squeegee. It will also depend on where you decide to cut your tools down to as only the tops are exposed. Since you already have a jumpsuit with pockets sewn on it, I would recommend finding a decent pic or two of how much of the tools are exposed, then measure how much you need to cut off the bottoms of them to show the same amount.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top