Show off: My upgraded ESB EE-3 blaster - Now with real MPP tube

kurtyboy

Active Hunter
EDIT: Just replaced the Heyland with an MPP. Pics in the last post.

-------------------------------------------------------------------------------------------
I originally built this five years ago but recently upgraded the clamps/mounts and square stock plates to something that looks a little more accurate. Also swapped out the resin AM plugs with real ones. I also really wanted to swap the Heyland flash tube for one of my real MPPs, but I can't get to them right now :(

Hand-Schaub bronze Webley with open/close action (static trigger unfortunately)
Heyland flash tube (soon to be upgraded to real MPP)
Real ASI 4x20
Real Molex plugs
Real AM plugs
Real Revel v8 connecting rods and vibration damper pulleys
Correct 1/2" scope rings
Stormrider clamps/mounts and square stock plates
Ogibendogy sling

fettesb1.jpg


fettesb2.jpg


fettesb3.jpg


fettesb4.jpg


fettesb5.jpg


fettesb6.jpg


If you're wondering why I only put 3 AM plugs on the stock, it's because I always liked this picture!
3plugs.jpg
 
Last edited by a moderator:
Out with the Heyland and in with the MPP!

Also replaced the scope mounts with a set from Sidewinder. Lacking in some detail but a better size.

fettesb7.jpg
fettesb8.jpg


fettesb9.jpg
 
Last edited by a moderator:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top