Rubber Knees v1

Nice work guys... they look great so far.(y)

I think you should have plenty of interest in these...and so glad the finer details didn't wash out.

**I think it should also be known that a Percentage% of the proceeds will go back to FP and Pam if this run happens, and during this time would def help them. (y)...glad to see these FINALLY happen after months of talking about it.

count me interested.:)

Alex
 
Going to be a long night in the garage tonight, getting these ready to pour some test pairs tomorrow I think.

Spent another 600 on rubber and other supplies, but im set to go with this.

As for how much. They are going to be $65 with 45 going to FP and 20 to cover the materials.

Once I have put a pair in a couple peoples hands and gotten a thumbs up, they will be ready to rock.

And I _think_ the cold cast wont be much of a problem, but until ive pulled one, I wont know.

M2
 
Minor update only. One mold is done, but the resin I have, isnt mixing properly. Im thinking I got a bad batch.

The rubber that I have, at 1/2 inch thick I can tear with my hands. Thats not acceptable. Ill be visting them monday early.

I also will be making another revision, to allott for aluminum knee darts.

Ill have a set of those to get the depths and widths correct.

The alum knee darts, wont be included in the kit obviously. But ill try to get a resin or rubber version thats the exact same size.

So much to do, and so little time:)
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top