ROTJ Blaster - attaching handle and stock

ukscout

Active Hunter
Im nearly finished constructing the Spiddey blaster but have no idea whats the best way of fixing the wooden stock and alu d ring to the handle of the resin blaster.

Im thinking of bolting the alu part to the resin handle and recessing some holes in the alu part so the nut to the bolt is flush.

But would like to here/see how other members that have the same kit how you did yours.

cheers

Neil
starwars20.ico

uk-scout TB7290
www.uk-scout.co.uk
ukbikerscout@hotmail.com
ukscout-webbanner.jpg
 
I have a spidey blaster kit as well ... VERY nice !
I chose to screw mine thru the aluminum bracket to the wood stock/handle. I don't have a real good pic of that area ... you can just see one of the screws in the bottom right of this photo !

blaster handle.jpg
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top