RafalFett's Boba Fett 3D Projects

Having some trouble with the Helmet Greeblies File. My friend who uses the 3D printer says that the way the file is set up, the parts are all over the place. The file created is a model of multiple parts and are all on a different plane, that some are floating in the air. Says the each part needs to lay on the print bed.

I only need the circuit boards printed. Is there a way to get just the circuit board files?
 
Here are the screen shots I PM'ed you about. I am signed in on both pictures.

snipit studs.PNG

Snipit circuit board.PNG
 
Thanks a lot Rafal, I have a 3D printer so these files will come in handy. Your contribution to this community is outstanding.
 
Hey Raf, are the 3D objects for the helmet the same dimensions as your V2 templates? Would it be possible to print the detail areas and ears and still have them fit my scratch build? And is the helmet the same dimensions as the V2 helmet? Sorry for all the questions, just wondering how compatible your files are with my build :)
 
Hey Raf, are the 3D objects for the helmet the same dimensions as your V2 templates? Would it be possible to print the detail areas and ears and still have them fit my scratch build? And is the helmet the same dimensions as the V2 helmet? Sorry for all the questions, just wondering how compatible your files are with my build :)

I used the measurements from the v2 helmet templates for the 3D model, so you shouldn't have problems fitting parts between them.
 
I dunno if you're looking for something new to 3D model, but you could also do a battery cover for the MQ 1 calculator that was used on the left gaunt :D I would seriously use that
 
Firstly Excellent work and a big thank you ! i think i said this on the other thread for the stencils.

Has anyone printed a full jetpack yet ? i would love to see the results ?

I am new to 3d printing so have no idea how its done, all i know is that some printers have smaller bed sizes so i would want to know how people assembled it together
 
Firstly Excellent work and a big thank you ! i think i said this on the other thread for the stencils.

Thanks for the kind words, sir!

Has anyone printed a full jetpack yet ? i would love to see the results ?

From what I know, no one printed the jetpack so far.

I am new to 3d printing so have no idea how its done, all i know is that some printers have smaller bed sizes so i would want to know how people assembled it together

Never tried 3D printing, so I can't help you in this matter.
 
Last edited by a moderator:
This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top