Question regarding MOW vest and neck seal

Carbonfreeze

New Hunter
Hey fellow Fetters I just bought a MOW flak vest and neck seal from a fellow member here at TDH but I'm a little confused as to how the neck seal closes in the back as there are no closures on it. Also I'm curious how others have prepped their vests for armor attachment. I plan on sewing Velcro onto the vest as my existing armor was attached to a prior vest using the same method. I guess my question is how do you lay the whole thing out so the armor is spaced and centered correctly on the vest. Any tips or suggestions would be greatly appreciated. If this has been discussed in a prior thread I apologize for this request. Thanks in advance.
Doug
 
hmmm.... I'm not an expert on this (I use magnets to attach my armor to the vest) but you could try marking lightly with a pencil or something where you want to sew the velcrow on. that way, once you stitch them on you can just wash off the pencil markings.

Good luck!
 
You should use a double-faced adhesive tape to fix the armor, mark the positions with a pencil, remove the armor and sew the velcro. After that, the pencil marks can be removed easily. That's the way i fixed my velcro and it worked well.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top