question on gauntlets?

Fett X

New Hunter
ok im constructing a set of gauntlets and was wondering how everybody is securing them on the unhinged side i had a few ideas but dont want to make them cheesy:p any help or ideas would be appreciated
 
Hi Fett X,
Depends what your gauntlets are made from. My set is vac' formed styrene, and to secure the 'outside' seams, I used super glue reinforced with 2 small screws/nuts (for each gaunt). For the 'inside' seams, I used the industrial strength velcro. As long as the surface is clean, and you let it set-up per the instructions, the velcro works really well.
Eric
 
superjedi said:
As long as the surface is clean, and you let it set-up per the instructions, the velcro works really well.
Eric

Uh oh. I just slapped my velcro on, and went to town. I hope my gaunt don't fly off while i'm striking a pose. :lol:
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top