New Templates

Foxbatkllr

Well-Known Hunter
I'm sure many others have already done this, but I modified the mandalorian templates to fit Boba's more correctly (or so I think). The black outline is obviously my template and in the background you can see the picture I used matched up pretty nicely. What do you think?

foxarmor.jpg
 
Not too shabby.

My only advice . . . don't try to be so "rigid" with your templates. There's a lot of things on Fett that just aren't symmetrical, or don't line up. Don't be afraid to put some curves in there. Every line doesn't have to be perfectly straight.

Certainly on the right track though! :)

Jer
 
Yeah I know about the rigid part, but this is designed to be cut out of aluminum and then bent at the edges, so I figured the corners will be rounded after the template's cut out.

Edit: About the symmetry, I had just guess the differences in each side would be a result of the creation process and not the template itself. This was more a test of trying to get the proportions right.
 
HI. If you are making your armor with aluminum my advice to you is to trace the templates and everything else [exactly the way it is].Metal can be tricky when bending and folding it can [change on you]and the results will not be the same as you truly wanted them. Another thing try to make whatever you are tracing a little bigger so you can grind and shape afterwards.
 
That's a good point about making it bigger. I'll definitely have to make it slightly bigger because I'll bend the edges inward.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top