My Painted RussRep Rocket...

deadbolt

Active Hunter
Here's my freshly painted russrep rocket. I'm happy with the paintjob(all of the black), but I'm not very happy with the misted-on grey. The arrow shows were the freakin' paint chipped off while I was doing the wash and mist...

rocket2.gif


rocket1.gif
 
Ronin677 said:
can you explain how you painted (a little step by step breakdown).
Sure man,

Step 1: I completely spray-painted every piece ultra-flat black.
Step 2: Next I scraped out all the details with an exacto knife.
Step 3: Then I sprayed on a light coat of satin polyurethane clear coat.
Step 4: Then, with a kinda dark grey enamel model paint, I brushed it (in small portions) on each piece, Then I emedietly started dabbing the areas that are painted with the grey with a paper towel, until it made the black look kinda grey. I didn't put any grey on the little fin things on the middle piece, exept the very bottom fins on each side. All of the top fins were left "un-washed"
Step 5: With some silver spray paint, I very lightly misted the entire rocket, but I sprayed a little more on the bottom side of the rocket.(You cant really see the silver at all in the picture...damn camera:lol:)
Final Step: I clear coated it again, and then the rocket is complete!

Thanks Guys!

-Carson
 
Last edited by a moderator:
Thanks guys! When I can get ahold of a better camera, I'll post some new pictures. These pictures dont really show the detail very well.

-Carson
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top