My Aluminium Chest, belly and shoulders

Bill

Jr Hunter
I decided to have a crack at making my armour today:


DSCF0418.jpgDSCF0422.jpgDSCF0428.jpg

Open to comments/feedback.

Bill
 
Your armour is looking good, I've also made a set of Aluminium armour, it's great to work with. I made the blaster dents in the armour with a 22. rifle, you should try it. Keep up the good work.bob's chest 2.JPG
 
Ha! It would be great to be able to make the dents that way but I'll just have to bash them in with something I think.

Thanks for the comment.
 
Thanks. I just put it in the vice and bent it with my hands

DSCF0424.jpg


The trick is to open the vice so that the armour is resting on the bit you want bent.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top