MR Vader saber hilt...good for ESB blaster?

godaking

Hunter
Not sure if this has been asked before, but I'm thinking about getting a used ESB MR Vader saber hilt. Would this be a good replacement for the actual MPP tube used in an ESB blaster and would it fit in a Webeley or Webeley cast?

-Joe
 
Not sure if this has been asked before, but I'm thinking about getting a used ESB MR Vader saber hilt. Would this be a good replacement for the actual MPP tube used in an ESB blaster and would it fit in a Webeley or Webeley cast?

-Joe


You talking the MR FX saber hilt??? If so, It is very heavey. It may work but it is not a light as a normal MPP.
 
I dont think its the right diameter. It feels about 1/4 to 1/2 inch bigger diameter wise, in order to hold the batteries. But I havent dug the sabers out yet.
 
even if it was to fit there are a few extra holes in it (for running wireing and such) that you would have to fill....Im not sure of your expertise with that kind of stuff but it sounds like a pain in the butt to me.
 
That's what I'm using in my EE-3...

102_1030.jpg

102_1040.jpg
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top