Making Red washer / gasket / o-ring for Knee Darts

f391261031d424abe830689bcc963ec4.jpg
3ddf11d73b3e5f5c97174eec0f23f8d9.jpg

Here's a rough cut of some grip thin from side view textured on front
I should add I cut this just now and with one contact just for a comparison and it's not black and it's brand new if it was worn it may look closer


Sent from my iPhone
 

Attachments

  • f391261031d424abe830689bcc963ec4.jpg
    f391261031d424abe830689bcc963ec4.jpg
    576.7 KB · Views: 203
  • 3ddf11d73b3e5f5c97174eec0f23f8d9.jpg
    3ddf11d73b3e5f5c97174eec0f23f8d9.jpg
    45.3 KB · Views: 169
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top