look what i've been making - pic intense

will be doing a bit more on it this week, needs sanding, filling and priming. Then just the rocket to make.

btw does anyone know where i can get the thrusters as i don't think i will be able to make those.
 
looking a little more symetrical but very untidy (putty all over it). I also installed the curved plate behind the rocket housing.

24.jpg


23.jpg
 
I have finally gotten of my backside and done some more on this kiddie. Its still very rough around the edges and needs a lot of sanding (and a bit more filling). I am currently working on the fuel cell caps (thanks WoF for the templates :) ).

anyway here it is.......

1.jpg


2.jpg
 
Hey Quinn :cheers

it is almost done now. I was just waiting to get a good coat of primer on it before i posted more pics. There is only one thing i don't like on it though and that is the diameter of the fuel cells (they are too narrow). This in turn has made the cell caps look too tall (you will see in the next load of pics).
 
Well just bought some 2 inch wooden balls for my thrusters. I will post pics ASAP as i want ot have them finished by the weekend.

100_0938.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top