JP + BP (sintra) Need To Know

Eht Eno

Hunter
Okay I have doing alot of research on this site and some others. Also went to see the local Sintra dealer. All said the same or somewhat the say .

Sintra can be screwed, has anyone tried this with the backplate? Bascially making it into one piece? I do realize this might be an issue if you have to repaint or anything,just a little bit curious.
 
On my jet pack, I made a wood inner structure. The I glued and screwd the back plate on. I worked well. But you will never be able to get back into your Jet Pack again.
 
I used plain old dry-wall screws to fix the central pipe to the main board of sintra in my pack and also to attach the "hangers" for my harness system. Worked pretty good.

However, sintra isn't that strong and with enough force the screws could pull out. I also used glue with them for additional support.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top