Jet Pack back

cal196

Well-Known Hunter
Jetpack back

I have no idea how to go about this and my other scratch built jet pack has a flat back, but for those of you who built your own. I have 1 question, how in the world did you do the back? Its thicker at the bottom than at the top, and the back is curved. Not to mention the upper part is about an inch wide, Do you just glue the material to it like an L shape and sand it down?

Maybe this picture will help explain

reprobobajet pack.jpg


I need some info on how to get the side view effect.
 
On my pack (it is made out of foam board) I just put it at the desired length away from the bottom of the pack then smashed it at the top. Hope this helps.
 
Last edited by a moderator:
This time I'm gonna try PVC pipe for the middle, quarter inch sintra, old spray cans. I plan on building the middle part up like I did last time from layered sintra, bondo and all that.

Any idea what to use for the fan outlet at the bottom?
 
Last edited by a moderator:
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top