Jet Pack Adjustment Knob

As with the gauntlet darts, I had a chance to photograph the jet pack adjustment knob. This piece is TINY!

rocketpack_part.jpg
 
Last edited:
Thanks for the pic Art Andrews. It looks like mine is pretty close. I just need the hole on top and bigger taper on the bottom part.

stabalizer.jpg
 
Last edited by a moderator:
ok, found some of the real mitchell pieces. located a retailer that can get some from his wholesaler who bought old overstock from the manufacturer. main difference is that the base is a bit thicker, needs to be milled down, or as another member here has suggested could be sunk into the jet pack. what you see in the pic is what you can get. no need to buy the entire sweeper arm! if you are interested you can pm me and i will give whoever is interested an email contact of the retailer. before i posted this i made sure that they will deal with overseas customers, as the retailer is located in germany and has been selling high end audio equipment for decades. i do not participate in the deals, i will not negotiate anything, i'm not getting a cut of what you pay, you can have the contact email the rest is up between you guys (and gals)and the retailer. i'm posting this cause i don't like to hold back stuff.
and just to let you know in advance, no other base is available, just the one you see. there is no more "needles/darts" or anything else left, just the base.
and i'm sure it won't even be near 250 bucks.

mitchelljet packpiece.jpg
 
Last edited by a moderator:
here's another pic with the screw taken off. the tube is a few mm off in height from seven's draving. but not by much. looking at the pre pro blaster it seems to be the same height though.

mitchelljet packpiece1.jpg
 
Last edited by a moderator:
Looks like a simple mod to me?
3 jaw chuck on a lathe and a parting off tool...
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top