Holster help

JangoBear

Active Hunter
Hey gang, I have a big question. I just got those sweet looking blasters for my jango but they turned out to be just slightly larger than my holster was made for. is there a way to strecth the leather any to make them fit? or am I looking at contacting RA for a new set?

Bear
 
You might put a small slit in the back of the holster to open and accomodate the gun. Problem is that it might end up tearing too much.

You could make the slit and punch a small hole in the tip of either side and reinforce it with a stitching or two. One of our garrison's more sew-friendly members might be able to help you, but I'm not naming names ;)

Phil
 
lol, um, you've referred to him as your best friend and he sews, uh, like everything? Ringing bells? lol...

I can't hold it against you, I know you've been trying to find your way around Vice City all day by now. I'm still getting lost.

Phil
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top