General Hello! New here and looking for help regarding Boba Fett's armor

RockinRobin

New Hunter
Hello,
I'm sculping my armor and I was thinking of Vacuum forming it with a ABS plastic sheet 1/8. Is that a good option to get it thick? Other suggestions are welcome and appreciated.
 
Hello,
I'm sculping my armor and I was thinking of Vacuum forming it with a ABS plastic sheet 1/8. Is that a good option to get it thick? Other suggestions are welcome and appreciated.

.090 ABS (.093 or 3/32 Ive also seen it) is good for armor.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top