Hasbro EE-3 Fett Blaster wip - now finished + bonus

The weathering was acheived with some 'light rust' pigment powder mixed with water and a dash of rust coloured enamel paint, then washed over liberally in 3 or 4 coats. Then when that's dry just some good old fashioned dry brushing/highlights with a silver enamel paint.

thanks for the comments!!!!

Now all I need is a helmet, some boots, armour, backpack, gaunlets, jumpsuit........................

Respect
P.
 
Last edited by a moderator:
Not worth it's own thread but whilst I had the paints out I thought this fella, long forgotten, in pieces in a acupbard, could do with a lick of paint too. :D

lifett.jpg


lilfetthelmetdetail.jpg


repropiccy.jpg


180830_500765584525_513889525_5923546_3381194_n.jpg


and same technique applied to his mini ee-3

lilblaster.jpg


Respect
P.
 
Last edited by a moderator:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top