Fett insignia

While 2.25 in may be correct for one size chest armor, it might not look correct for a smaller (or larger) set of armor.

Below this image shows that the logo is about 1/3 or a little less of the length across the top of the armor piece. I have added scale lines to show proportion, image from the MOM exhibit.
fettchest.jpg
 
Last edited by a moderator:
Thanks,actually hadn't taken into consideration of the size difference, but that will help a lot. I'm still not quite there yet tho I'm practicing weathering and what not on the other armor.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top