Extending the kidney piece, how should it look? (Bobamaker armour)

Lisa

Jr Hunter
I have a Bobamaker armour, and I need to extend the kidney piece to make it reach the cod piece. I'll be using abs as a foundation and fibreglass on top of that, I think. But how should I shape it? It is kind of round at the ends, so there's no way to extend the lines in a good way.

P1010137.jpg
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top