Blaster ESB Recipe

Here it is.

ESB Wes7.JPG

SAS
 
Finally finished my new ESB barrel mounts:

ESB mounts.JPG

ESB mount mock2.JPG

ESB mount mock.JPG

Made from the incorrect Maclow clips spliced together and a modified metal aircraft clamp and are double sided (unlike my old ones). Top 'U's are scratch built.

They're made using a bit of guestimation in some areas, but I'm pleased with how they turned out and think they look quite close given the ref I have (SCaps).

I've left off the mystery detail on the front one that goes around the threads as there is no firm evidence either way (plate/wire/washers/nothing).

SAS
 
... I'll say they are! Picked up a set of these from Simon and they are superb!! A much sturdier mount for the scope. Overall , more interesting detail to look at. Not sure if I'll add washers to the front bracket. By the way , Simon got these to me in under 24 hrs!!


Sent from my iPhone 2
 
Strictly speaking no, the rear was a 'swimming pool pipe clip' that came in white plastic instead of the grey plastic of the Maclows.

It does have 1 1/2" / 50mm written on it.

SAS
 
Another EE3 with new mounts rolls out to the US, good news (i hope) for the recipient and also for all those waiting as your one step closer to yours.

ESB Brandontrueblue.JPG

SAS
 
Was there ever a decision made on the origin of the barrel mounts? I know you were discussing that in regards to the current ones you're using.
 
This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top