Blaster ESB EE3. Search for barrel mounts found parts discussion.

Those look nice sidewinder.

I have looked at every pipe clip, pipe clamp, and pipe bracket I can find. I guess the hunt for the real part continues.
 
Has anyone else ever shouted at Fett in the screencap to hold his blaster up to see underneath or move his bloody hand out the way?

I feel the need to apologise to the lovely JB next time I see him.

SAS
 
You know....... the top "U" piece almost looks like a chopped version of the upper part of each clip that's been turned 90 degrees......

Not exact, but similar shape.
 
Last edited by a moderator:
A bit of solder wire wrapped round the exposed thread:

ESB mount F wire (1).JPG

ESB mount F wire (2).JPG

SAS
 
I'm still trying to find that metal aircraft exhaust clamp..... getting that shape down at the bottom is a bugger.....
 
Glad to see this topic. About 4 years ago, I posted a computer mockup of what I thought they looked like. I asserted the center pole was round not square, and that the front mount was not all the way around. I did a workup that caused a **** storm. My final version is very similar to sidewinders, but I started with the post below, before going back to what was more 'widely' accepted.

mounts.jpg


As always sidewinders look great.

The only thing I would like to add here is in one of the pictures of the rear mount, you can see circles/holes all the way around the mount. Either lending to injection holes or a metal clamp around it.

The photo came from Phillip Wise, but I do not know where it is now. But I am sure you could find it.
 
Last edited by a moderator:
It was from a large print at phillip wise' house. I don't however see the holes in the bridge shot, the shot I worked off of looked like there was a metal ring clamp around the back clamp evenly spaced dimples/holes.

I would like to have a set of these pool clamps to use as a starting point to finish up my redo of my mounts before making new molds. Can anyone procure a set for me.
 
Last edited by a moderator:
It was from a large print at phillip wise' house. I don't however see the holes in the bridge shot, the shot I worked off of looked like there was a metal ring clamp around the back clamp evenly spaced dimples/holes.

I would like to have a set of these pool clamps to use as a starting point to finish up my redo of my mounts before making new molds. Can anyone procure a set for me.

I can if you can wait until I get paid.
 
I will take you up on that if you give me a price etc intwenothor. Thanks.

Until then, I have dug out and played with my scope mounts for the new kit. I will post a pic tonight when I get some paint on them that is the right color.
 
intwenothor:

Where can those clips be purchased? they look pretty close. They could certainly be modified. Easier to start w/ than a total scratch build.

SPY007
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top