ESB Boba Fett Sidearm 3D CAD model

berkal

Hunter
I thought I would share with you my WIP CAD model of the ESB Boba Fett Sidearm. Built using Microstation and Sketchup.

pulce_1..jpg

If any member in the UK has access to a 3D printer I would be interested in speaking to you about realising a solid prototype.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top