ESB Blaster Question - Flash Supressor

Hello Everyone,

I have a stormrider ESB Blaster on the way and I need to make or purchase a Flash Suppressor (I think that is what it is called). What options do I have to make this? Stormrider said I could get a pipe from HomeDepot, is that the best option? What size pipe do I need? How long does it need to be?

Thanks everyone.
 
the chrome tube on the front i believe is a heiland flash gun . i could be mistaken though . they are on ebay un complete for like $50
 
image.jpg

Fett 4 Real, is right. This is the tube used for the barrel extension. Very hard to find and usually very expensive too. A Heiland is a very close match for it.
 
Tubes at home depot are $5. SR is talking about a 1.5" sink flange. Youll have to drill the holes in it. They may cut the flange off at HD if you ask them.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top