Diver belt buckle

Roddie

New Hunter
Real quick....How in gods name do you thread the seatbelt webbing into the diver belt buckle.
Every way I do it, It doesn't want to hold? Im going crazy over here. I don't understand how I can manage to build a complete Fett but am
unable to figure out a simple belt buckle

any help would be life saving, Thanks in advance.
-R-
 
Here ya go.
Not a US Divers buckle, but same technique.

weightbelt1.jpg

weightbelt2.jpg

weightbelt3.jpg


Us noobs gotta help each other out.
 
This first set of pictures showes how one end of the betl goes through the ladder lock on the buckle.

Shown front and back,with the webbing loose show you can see the path it takes. Then with all the slack taken up.

20141014_100842.jpg


20141014_100858.jpg


20141014_100916.jpg


20141014_100933.jpg
 
The next two pictures show how the other end of the belt passes through the buckle. Shown with the belt tab open and closed.

With the tab closed it should be clamping onto two layers of belt webbing

20141014_101026.jpg


20141014_101040.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top