Birth of a Jet pack

After trimming the flashing, sanding, and primer I cut out the back access panel. My current method of reattaching the back panel is low tech.

IMG_0593.jpg


IMG_0606.jpg


IMG_0590.jpg


IMG_0604.jpg
 
More progress pics, I've been asked why don't I have the piano keys molded in. The answer is , I only have one JP body mold. The "base" of the pack will serve as a Classic and Arena JP. So with that said I add the piano keys after. Yep, I glue them one piece at a time, fun stuff.

IMG_0607.jpg


IMG_0610.jpg


IMG_0612.jpg
 
Casted up a few more parts of the kit. Glued down the base of the rocket, aka the Castle Ring. Fitted the rocket into its base.

IMG_0625.jpg


IMG_0627.jpg
 
Haven't posted much on the jet pack build lately, so the next update is for an Arena pack kit I'm developing. The bits in the photo are the side bolts on the Jango pack. The title of the photo is call "scratch, mold and cast"
I know this is a Boba thread, but it all stems from the same JP, its all good.

Arena parts 007.JPG


Arena parts 010.JPG
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top