BBF's ROTJ Fett - No More "SE"

BooBoo Fett

Active Hunter
Finally finished (for the moment) my ROTJ Fett. Now I can drop the "SE" designation and retire my MR Helmet :)

Some fine tuning to do yet. Wanted to finish in time to take my Fett on our 3-day Halloween cruise leaving tomorrow. Will be updating this post with new part list and proper photos. For now, here are some junk pics in bad lighting as a preview.

Note: The XLR cable on the JetPack does run around the side and up into the chest armor, and supplies the power to the chest display. One of my favorite mods for my ROTJ.

Cheers all !!!

BBF%20Parts%20Call-Out.jpg
 
Last edited by a moderator:
Thanks everyone!. Went SE to start with as I had bought an MR helmet when I was ignorant to the differences between ESB and ROTJ. Can't wait to have some proper photos taken. The pics above make me look fat. Must be the lighting :)
 
Terry where can i get me the plug for this? I have the female connector from BobbyFett but dont know where to get the male plug to plug into it...hook me up
bbfs-rotj-fett-no-more-se-dscn1414-b.jpg-47769d1288327581
 
As we all know, it never ends. It's never finished :) On that note, my helmet is out for repaint by Fett 4 Real. Really looking forward to seeing it.
:cheers
 
Pics of the process coming in a few hours when i get home

It no longer has any paint on it just primer, and its going to get scratches and layered paintjob
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top