Blaster [AUS] Hasbro blaster coversion

skeg man

Hunter
G'day all!

So while all my parts are gradually turning up. I decided to work on a Hasbro ee-3 conversion. Being in Australia, there is no real chance of importing any kits. So I had to work with what I can get a hold of.

I pretty much only kept the pistol body and scrapped the rest. The barrel is made from PVC pressure pipe (48mm OD) and the T mold is two plastruct right angles (1/4 maybe?) glued together. The overall look is good enough. But maybe a tad over sized?

The stock is built up from laminated sintra (fourex, foamex).I think it came out ok.. once again, maybe a touch too long.

Anyways.. any input would be great. I'll be sure to post up my armor and so forth once I start. ;)

Cheers for reading :)


uploadfromtaptalk1391428129152.jpg

Sent from my PadFone
 
Looks really good. The length looks to be about right. The barrel looks a little large because the pistol & chamber portion of the Hasbro gun is smaller. A really nice start. Were you able to keep all the electronics working?
 
Cheers for the input. I did keep the audio but the LED effect I wasn't too keen on. I also made a lager trigger guard, which gives the impression of a larger body.

Sent from my PadFone
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top