Armor question

Im restoring my Boba armor and It's made of Styrene. My knee doesnt have that dent on the edge. Does anyone have a suggestion as to how to put that dent in it?
 
On my knees I had to make my dents and I took and heated a spot where I wanted the dent with a lighter until it got really soft and pushed in the spot with a thick marker to make my dents.
Just gotta watch getting it too hot as it will scortch the plastic melt it more then you need it to.
HTH,
Lynn
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top