Anyone make a metal cast Webley replica?

Folks

I've been wondering, does anyone know if someone makes a metal/Ali webley receiver/barrel replica? I know this would make the thing very heavy..... if thats the case, then what about just a cast of the receiver (inner grip, receiver, trigger assembly) in metal?

Also, the two bridge clips to which the scope attaches too, are the orginal customs parts or are they somesort of drain pipe clips?

thx
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top