Alum Beacon & Stabilizer

Parts arrived and gorgeous as always Sean! Thanks!Now when are we going to try the ESB Flamethrower list again?!
 
Last edited by a moderator:
i'm a little curious about installing the beacon and stabilizer on a MOW jet pack. the base of the beacon is not threaded very deep, so i'm guessing it's not supposed to come through from inside the jp. so should i drill a hole for feeding wires through from the inside then goop the base externally so i can easily remove the beacon by unscrewing it?

on the stabilizer side there's already an elevated section for the resin stab that comes with the kit. should i grind that down and drill a hole through so it can attach on the inside?
 
hi put me in the list with a set of the alum beacon and light up stabilizer

please send me a pm confirm my order and send me your paypal account
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top