General 3D Printed Replica of 6051 Mini Light in the Works

T

toolguy301

Guest
Thought I would give a preview of something that I have been working on. Designing up a replica of the 6051 mini light to be 3D printed from visual references & to be made into a working flashlight. Getting close to completing it & plan on offering it for sale if there is any interest? Here are some renders of the model.

Ever_Ready_Mini_Light_1.jpg


Mini_Flashlight_ISO_Flip_1.JPG


Ever_Ready_Mini_Light_Swith_1.jpg


Ever_Ready_Mini_Light_Bulb_Housing_1.jpg


Ever_Ready_Mini_Light_Battery_Housing_1.jpg
 
The plan is to make this fully working & am working having a prototype done in a few weeks trying to get everything together for that to prove everything out.
 
Then this is a very interesting project. Are these very rare?

VERY...I wasn't able to find the correct one after looking for almost 2yrs. The 6050 is close, and the only one I was able to find. I recently picked up the correct one here, missing the switch, but I can use the one from the 6050.... Or maybe get one from tool guy actually :)
 
Wow, I must be lucky then. Picked one up almost straight away when I looked. I Just searched for 'ever ready torch'. 'Torch' the word used to describe such items in the U.K. I didn't even think about using terms such as 'minilight' or 'flashlight'. Anyone selling anything like that in this country simply calls them torches.
 
indeed you bastid LOL ... yea i have searches saved on e-bay for Ever ready minilight, ever ready flashlight, ever ready torch, every ready 6051, etc..they rarely pop up. You def got lucky brother :)
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top