stalk dimensions

Ronin677

Well-Known Hunter
Hi ppl

only me again!!!! :)

i was wondering if anyone had the dimensions for the rf stalk, in particular the cross sectional dimensions ie width.
 
Good question, I'd like to know too, I have a curved DP stalk that needs to be replaced with an aluminum one. I think my DP stalk is about 1/4" wide.....but it's at home and I'm at work so I can't really measure it from here. There were some measurements on TK409's site but it doesn't really show from which point, it just says RF Stalk 187mm?? Don't know if that includes the RF or not?J-ROCK
 
This is measurements I took from my BKBT aluminum stalk (which BTW if you're interested is getting one, look into his.), hope that helps.
bkbtstalk.jpg

*Also - It's 6mm Thick
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top