ESB Gaunt Help please ...

Nocturne

Active Hunter
Hi,
I've picked up (from ebay) an ESB Gauntlet kit (In fibreglass and ABS) but I'm a tad confused over a couple of things when it comes to putting them together...

1> Flamethrower - should the nozzle (longest part ofthe thrower) be uppermost or lowermost - I've seen both, but can't find any decent ESB pics to see for myself)

2. Hoses - I know there's a hose from the right gaunt (that dissapears under the upper sleeve, but is there a hose on the left gaunt?

Can anyone post up some useful reference pics pls?
Many thanks.
 
1) Assuming you bought one of the 'standard' design flamethrowers out there, the long bit should be at the bottom. Attached some photos.
2) Nothing come out of the left gauntlet, just the right, right? Not left, right? Right. Again, attached a photo.

Bespin_4.jpg


Boba_Fett_012.jpg


Boba_Fett_1156.jpg


Boba_Fett_931.jpg
 
Great thanks for that. :)
Looks like I have to make the mounting braket that sits underneath it - that didn't come with the kit :(
Still can't be too tough.
Thanks for the pics - much obliged.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top