Republic Commando bucket

mandalore697

Active Hunter
Hi folks,

I'm starting to make a RC bucket. I got the inspiration when I saw one on eBay a few weeks ago now.

I'm planning to make the base out of cardboard, make a two part mold and then FG the cast.

Can anyone suggest what I should use to make the cast? Or any other suggestions/improvements you may have.

Cheers

Dan
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top