Could This Work?

Dentedarmor

Active Hunter
I'm thinking of making my own ee-3, would this rifle butt i found on eBay work? Its cheapsih but i dunno how i would attach it to a flimsy plastic toy revolver? :facepalm


Thanks




Butt.jpg
 
Yes, That can work. I edited your image.

Butt.gif


Cut the sections off. Where you see blue, you should sand this down to a ... small curve so your wrist and arm fit better. See this image for what I mean about the curve. I stole this from R Boba:

attachment.php


Where you see yellow, that would be where you can screw the metal connector in. You should shave a small section out so the metal piece fits there.

You can make that metal connector out of aluminium, plexi-glass, etc. Once you have that made, screw it to the stock and the gun.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top