Latest upgrade to by Dwedd bucket - A shiny new Borden connector!

Reverend Scapegoat

Active Hunter
I dremmeled it in half, polished it off a bit, and used 2-part 5-minute epoxy to stick it in place.
Whatcha think?

ScapeyHelmetWithBordenInstalled.jpg

^Click for big.

Also, I've gone with the "Velcro the visor in" idea.
It seems to work quite well! Sadly, the visor's not QUITE as easy to see through as it was when I got it, as I had to reheat it a bit to get it into the right shape to fit the helmet... It warped slightly.
Still... It could be worse!

ScapeyHelmetWithBordenInstalledInterior.jpg

^Click for big.
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top