How to repair a crack in MS2?

bobafett669

Active Hunter
I got a crack in the MS2 I bought while sanding it. Anyone know how I can seal it?
crack.jpg
 
IS the visor installed? IF not, I would probubly just put that in and bondo over the crack without any glues and whatnot, the support of the visor should get it strong together, the crack looks like its just it the gelcoat it would be hard to glue that without it showing badly.
 
MARROW SUN said:
Dude, don't use bondo for a hairline crack, use superglue it will fill in much easier and sand off cleanly.

Yeah Mike, Listen to Marrow, I mean listen to ME and CAL, I mean listen to MARROW... !!!:lol: :lol: I'm sure this is helping you.:p

Seriously... Marrow is more of an "expert"...Mr. Helmet MAN..(y)
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top