Helmet Help Please

TK Devo

Active Hunter
I am about to start on my helmet and i am doing it all by hand i was wondering how can i get the back of the helmet curved without looking bad?
 
thats not the back... thats the dome you could use the ball for... but i dont recommend it, as Fett's helm basically has the form of a skull, an oval more then a round ball...

and well if you're worried about how to curve the back... have you tackled the mandibles yet... or the T-visor.

plexi-glas , fiberglas, ABS, sintra... all materials that can be used for a bucket... even aluminium can be used for one.

the plastics can be bend with an oven or a heat gun, or you can try vac forming...
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top