Sithlord 23's Scratchbuilt ESB Blaster rifle. PICS!

sithlord23

Well-Known Hunter
hey all, here is my scratchbuilt ESB blaster I've been working on, for a few months. It finally started looking like something!:lol: Well, its stock, grip and connector area, are all sintra cut in layers. The barrel area is PVC pipe from Home Depot. The scope is some old BB gun scope I found(not entirely accurate, but looks cool. plus I can replace it when I find a better one. Blaster blocks, are doorstop wedges glued together. The side barrel detail is super sculpey clay. I've got to get some stock greeblies, and real blaster blocks, but right now it looks good enough for me.

Thanks for looking!

SEE 2nd & 3rd POSTS FOR REST OF THE PICS;) ...

tdh.gif


tdh2.gif


tdh1.gif


tdh3.gif


tdh4.gif


tdh5.gif


tdh7.gif


tdh8.gif


tdh9.gif


tdh13.gif
 
I must say that is a great reproduction of the ESB blaster...wow the creativeness of you folks still blows my mind everytime. Can I ask where did you get all of your materials and how much did this little project cost you? Keep up the good work!
 
thanks guys-

Well it probably cost me- about 40.00 total

super sculpey- 10.
scope- 11-12.
pvc tubes- about 9. total
sintra- scrap pieces- 5.
JB weld- glue
dremel- already had it..
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top