Visor question ?

FettTheHunter

Active Hunter
Hi :)

Just want to run my visor idea past you folks (y)

I think I have figured out a idea to make the perfect visor ( I doubt it is a new idea though ) ..... has anyone ever used/made a shaping jig/thing with which to shape the heated acrylic sheeting ( or whatever that plastic stuff is called ?).
That way a person could knock out a visor whenever they needed one (y).

Like I said I rather doubt it is a new idea :)

Thanks
 
I've seen some on ebay where the seller has a steel or wooden template so you can make multiple visor cuts the same every time.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top