Earpiece question

Shinobi Fett

Active Hunter
Does anyone know a reliable and non-destructive way to pry off the RF earpiece from a DP 97? I'm starting a re-paint, and I'd like to replace the stalk and paint the piece separately. It appears to just be gued on, but I wondered if anyone has some insight.

Thanks

Shinobi
 
I had to pry mine off my DP '96, and it came off fairly clean. What I did was I took a razor blade and separated it as much as I could with that, and then just popped off the rest. If you get most of the outer glue, you should be able to pop the rest of it off with no problem.
 
I was fortunate enough to get a 96 Rubies, but I think they aren't that different. Mine has what looks like plastic rivits holding the RF ear on. I think when I go to kill mine, I'll probably use a small drill to get rid of the rivit "shelf". :wacko
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top