How do yo get your chest lights to stay?

shortimer52

Well-Known Hunter
Well how do you get your chest display to stay in? glue? velcro? cut the vest or not?


Last little info ill be asking about for a while.
 
I just duct taped mine to the back of my chestplate. I'm sure there's better ways of doing this, but I couldn't think of anything.
 
I hotmelt glued mine in. Make sure to use high temp, the low temp will fall out. I also did cut a hole in my vest for it. I have shackman's lights, and they have a 2nd peice that I attached to the other side of the vest on the indside of the vest. I did that with a peice of elastic that I just sewed on.
 
I took some pieces of plastic and created a grid that cradles the lights in place along with the other components (aka battery)
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top