Molding and Casting help....

PropReplicator2

PropReplicator2

Active Hunter
Hey guys and gals... I was looking at molding and casting some scratchbuilt parts for my fett and was looking at casting in gelcoat and fiberglass. It's an aluminum part if that helps any. I was looking at what type of silicone would be best for this type of mold? Any help is appreciated!

Thanks
Mike
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

K
Overseas Shipping (Help!)
Replies
1
Views
497
jikawa
jikawa
Motor Trooper
ESB Flak Jacket and Armor
Replies
1
Views
480
BudaFett
BudaFett
T
Looking for help finding frankenhead sized helmet and armor
Replies
8
Views
957
Halo 1
Halo 1
C
Need help to contact with Alex Lane (toofastrobot)
Replies
2
Views
1,000
Chips
C
BudaFett
Sideshow Boba Fett and Han Solo in Carbonire PF
Replies
4
Views
745
BudaFett
BudaFett

Similar threads

K
Overseas Shipping (Help!)
Replies
1
Views
497
jikawa
jikawa
Motor Trooper
ESB Flak Jacket and Armor
Replies
1
Views
480
BudaFett
BudaFett
T
Looking for help finding frankenhead sized helmet and armor
Replies
8
Views
957
Halo 1
Halo 1
C
Need help to contact with Alex Lane (toofastrobot)
Replies
2
Views
1,000
Chips
C
BudaFett
Sideshow Boba Fett and Han Solo in Carbonire PF
Replies
4
Views
745
BudaFett
BudaFett
Back
Top