bobamaker
Active Hunter
OK, I have been working on the keyslots today, so I've produced a little step by step picture guide. The slots are made from 3mm sintra, hopefully the pictures will make sense. I just need to glue this panel into the cutout at the back of the helmet with epoxy filler now and do more sanding! Oh, I took a shot of the inside also, it's a bit messy in their but this won't matter when I make the molds!
I will try my best to photograph the remaining stages as the helmet progresses... I get too involved sometimes and go steaming ahead!
I will try my best to photograph the remaining stages as the helmet progresses... I get too involved sometimes and go steaming ahead!
Last edited by a moderator: