Servo Shaft Extension for the HS-77BB

Ordin

New Hunter
Hello Everyone,

It looks like the Hightec discontinued the .250 servo shaft attachment.

Does anyone know a different shaft attachment that can be used?

Thanks
Josh
 
In my fiber glass Jango lid, I didn't need very much extension. The brass shaft with set screw worked out for me.

extention.jpg
 
I'm having issues with a micro servo I was given, trying to find a shaft extension... I don't know if I should try to fabricate something or switch to a different servo... any ideas? what I have is a Tower pro SG91R
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top