Helmet Help for Pepakura helmet

commandantbrice

Active Hunter
Hello, I launch into the construction of a pepakura jango fett helmet , can you give me advice?
Is there better one method than the pepakura?
How the resin?
Thank you for the answers
 
Last edited by a moderator:
If you can afford it, you are better off just buying a finished helmet from one of the vendors on this site. The helmet will be a complete kit most likely and al you will need to do is sand, primer, paint, and install the visor. That's much easier and faster than all the printing, folding, epoxy or resin you will need to do. Just my 2 cents.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top